How to choose the cabinet, what kind of board for the cabinet, the classification of the counter top, how to buy the hardware, what problems to pay attention to when buying the cabinet, do you know the answers to these questions? Today, Xiaobian will answer you one by one.
A look: the edge of the board
The edge of the high-quality cabinet is fine, smooth, feels good, the sealing line is smooth and smooth, and the joint is fine. Professional manufacturers use edge straightening machine to complete the process of edge sealing, broken head, trimming, chamfering and polishing. The glue is evenly applied, the pressure of the pressure-sealing edge is stable, and the workstations on the assembly line work continuously, and the precision of the processing size can be adjusted to the most suitable part to ensure the most accurate size. The small factory uses a brush to apply glue, manually presses the edge seal, uses a knife to trim the edge, and uses a manual polishing machine to polish. Because the glue is uneven, the resulting edge seal is uneven, the seal line is undulating, and even the edge is sealed. There is a feeling of sliding hands. Because the pressure is not uniform, many places are not strong, and it is easy to open the rubber in a short time. Once the sealing edge falls off, there will be a phenomenon of water intrusion, and a large amount of toxic gas such as formaldehyde will be released into the air. Harm to the human body.
Second look: punching
Today's panel furniture is assembled with three-in-one connectors, which requires a lot of positioning holes on the board. The fit and precision of the vacancy will affect the structural robustness of the cabinet. Handmade small factories use ** drill holes. Due to different positioning criteria and large dimensional errors during positioning. The precision error of the hole position matching is very large. In the process of box combination, even the hole position can not be matched. Therefore, the combined case size error is large, not a very regular square body, but is distorted.
Three look: cutting board
The cutting board is also called the opening of the board, which is the first process of cabinet production. The performance of the precision equipment is stable. The dimensional accuracy of the board is very high, the tolerance unit is in the micrometer, and there is no collapse at the edge of the board.
The small manual factory uses a small manual to open the data. Even using a woodworking material to make a simple operation table, the plate size error caused by this simple device is large, often more than one millimeter, and often collapses, that is, the plate substrate is exposed.
Four look: door panel
The door panel is the face of the cabinet, just as important as the human face. Everyone wants to choose a good-looking "face" for their cabinets. Deformation and distortion "face" are certainly not in the list. Door panels produced by small factories are susceptible to moisture deformation due to improper handling of the substrate and surface processes.
Five look: the assembly effect of the whole set of cabinets
The small gap of the cabinet should be even and the door panel should be straight. Any dimensional error in the production process will be displayed on the door panel. The door panels produced by professional manufacturers are horizontal and vertical, and the gap between the doors is even, and the cabinets produced by the small factory will have uneven door seams, uneven gaps and large Small, the door panel is not on a flat surface.
Six look: the slide rails of the drawer
Although it is a small detail, it affects the important parts of the quality of the cabinet. Due to the dimensional error of the vacancy and the plate, there is an error in the matching of the sliding rail mounting dimensions. The condition that the drawer does not move smoothly or loosely. Also pay attention to the uniformity of the drawer gap.
Pure Essential Oil,Essential Oil,Aromatherapy Oils,Grape Seed Oil
Ji'An ZhongXiang Natural Plants Co.,Ltd. , https://www.zxnaturaloils.com